Skip to main content
NetApp Knowledge Base

Amber LED after disk replacement due to disk autoassign misconfiguration

  1. Last updated
    Nov 5, 2020
  2. Save as PDF
Views:
1,421
Visibility:
Public
Votes:
0
Category:
disk-drives
Specialty:
HW
Last Updated:
11/5/2020, 12:59:08 PM

Applies to

  • All FAS/AFF platforms.
  • ONTAP 9

Issue

  •  After disk replacement the Amber LED is ON
  • Fault status reported by drive:

cluster::> system node run -node node1 -command storage show fault -v

18 [Bay 18]: OK 01,12,00,20 FAULT REQSTD

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.