Skip to main content
NetApp Knowledge Base

How to configure a node with 10G cluster ports on a new cluster setup using the X1147A card

  1. Last updated
  2. Save as PDF
Views:
1,071
Visibility:
Public
Votes:
1
Category:
ontap-9
Specialty:
hw
Last Updated:

Applies to

  • AFF A400
  • FAS 8300
  • FAS 8700
  • New Cluster Setup

Description

Certain platforms support 10G connections to legacy Cluster Interconnect switches using a X1147A card in slot 2. 

  • The cluster will attempt to use e3a and e3b as its cluster connections by default. 
  • This procedure outlines the steps to modify the Cluster ports during cluster setup to use the 10G ports in Slot 2.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.