Skip to main content
NetApp Knowledge Base

Unable to modify SolidFire VLAN start IP of the block

  1. Last updated
  2. Save as PDF
Views:
233
Visibility:
Public
Votes:
0
Category:
element-software
Specialty:
solidfire
Last Updated:

Applies to

  • NetApp SolidFire
  • NetApp HCI
  • NetApp Element Software

Issue

Attempt to modify start IP of the VLAN block fails with the error:
 
ModifyVirtualNetwork Failed: Existing address block is in use, cannot remove. mID=x

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.