Skip to main content
NetApp Knowledge Base

tsse.scan.start.failed: 'Cold Data Scan' failed to start

  1. Last updated
  2. Save as PDF
Views:
761
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

  • ONTAP 9.8
  • Storage Efficiency/ Data Compression
  • FabricPool
  • Temperature Sensitive Storage Efficiency (TSSE)

Issue

  • Every time when the data compression runs, it gives out the following error:
  •  vol efficiency inactive-data-compression show -vserver vs0 -volume vol1

 Volume: vol1
 Vserver: vs0
 Is Enabled:  true
 Progress:  IDLE
 Status:  FAILURE
 Failure Reason:  Scan was stopped

  • event log show

ERROR         tsse.scan.start.failed: 'Cold Data Scan' failed to start on 'vol1' - Scan was stopped

  • The issue started after enabling the FabricPool.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.