Skip to main content
NetApp Knowledge Base

"disk replace" fails in ONTAP with error message: "Disk X is not of appropriate size"

  1. Last updated
  2. Save as PDF
Views:
1,710
Visibility:
Public
Votes:
1
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies To

  • ONTAP 9.6 or earlier running Advanced Disk Partition (ADP)
  • FAS2552 
  • FAS2554

Issue

  • The following command fails on a partitioned disk right-sized into a smaller aggregate with a whole disk of appropriate size:

::*> disk replace -disk VMw-1.31 -action start -replacement VMw-1.28
Error: command failed: Disk VMw-1.28 is not of appropriate size.

  • The system should partition the new disk but fails with the error below seen in the EMS:

[cluster-01: mgwd: raid.disk.replace.job.failed:error]: Failed to replace 
disk 1.20.0 with disk 1.10.11. 
                Reason: Reserve: Unable to reserve disks on source node cluster-01.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.