Disk status is replaced with a star ico in Array Management. One disk has been failed manually and manual reconstruction has been performed, and then the operation of disk revive.The disk displays rep...Disk status is replaced with a star ico in Array Management. One disk has been failed manually and manual reconstruction has been performed, and then the operation of disk revive.The disk displays replaced status with a star ico in Array Management Raid reconstruction is not completed, so the drive will stay in a replaced state until this completes. Note: You might see the copy back or the reconstruction progress, which will always say 0% because the controller does not own that volume.
Applies to FAS Models AFF Models ONTAP Disk Shelves ONTAP 9 Description The hot shelf removal procedure requires that all disks within the shelf are spares, failing to do so will cause a system outage...Applies to FAS Models AFF Models ONTAP Disk Shelves ONTAP 9 Description The hot shelf removal procedure requires that all disks within the shelf are spares, failing to do so will cause a system outage and data loss One method of returning each disk on the shelf to a status of spare is to use the "storage disk replace" command to move the contents of each file system disk to spare disks residing on other shelves owned by the node
ONTAP 9.6 or earlier running Advanced Disk Partition (ADP) The following command fails on a partitioned disk right-sized into a smaller aggregate with a whole disk of appropriate size: ::*> disk repla...ONTAP 9.6 or earlier running Advanced Disk Partition (ADP) The following command fails on a partitioned disk right-sized into a smaller aggregate with a whole disk of appropriate size: ::*> disk replace -disk VMw-1.31 -action start -replacement VMw-1.28 Error: command failed: Disk VMw-1.28 is not of appropriate size. The system should partition the new disk but fails with the error below seen in the EMS: disk 1.20.0 with disk 1.10.11.
Disk Qualification Package (DQP) Disk failed and replaced. Listed in sysconfig -a output. The replaced disk is listed as spare and not replaced in the RAID group. RAID group /aggr4/plex0/rg0 (normal, ...Disk Qualification Package (DQP) Disk failed and replaced. Listed in sysconfig -a output. The replaced disk is listed as spare and not replaced in the RAID group. RAID group /aggr4/plex0/rg0 (normal, block checksums) RAID group /aggr4/plex0/rg1 (degraded, block checksums) RAID Disk Device HA SHELF BAY CHAN Pool Type RPM Used (MB/blks) Phys (MB/blks) data FAILED N/A 7486157/ - Disk Qualification Package Details: Package Date: Unable to load any package (Package version not supported)
