Skip to main content
NetApp Knowledge Base

MetroCluster Configure fails due to system ID conflict

  1. Last updated
  2. Save as PDF
Views:
418
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • MetroCluster Configurations
  • FAS Systems
  • ONTAP 9

Issue

MetroCluster configure fails noting:

CLUSTER::> metrocluster configure
[Job 259] Configuring Clusters[Job 259] Job failed: Configure command failed on node "NODE-1" in the local
cluster. Reason: (Local node's system id in the nodelist does not match the
NVRAM system id). Check the hardware for errors and make sure all remote nodes
are online, then try the command again with "-refresh true". Use the
"metrocluster operation show" command to view detailed error information.
Resolve the errors, then try the command again.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.