Skip to main content
NetApp Knowledge Base

How to use boot menu option "(6) Update flash from backup config." within ONTAP

  1. Last updated
  2. Save as PDF
Views:
3,860
Visibility:
Public
Votes:
3
Category:
ontap-9
Specialty:
HW
Last Updated:

Applies to

  • AFF Systems
  • FAS Systems
  • ONTAP 9

Description

  • Typical boot device replacement procedures use the system node restore-backup command to copy node configuration information back to the node with the boot device replaced. 
  • While this is the recommended procedure, there might be reasons this command is not available to utilize in all situations. 
  • This article describes an alternative option.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.