Brocade CP blade not reachable via management port
Applies to
- Brocade X6-8 Director
- FOS 8.2.x
- CP blade Management (MGMT) Ethernet port
Issue
- CP blade not reachable via Management (MGMT) Ethernet port
- Bond interface down and eth0 shows
NO-CARRIER:
/sbin/ip -s link:
: eth0: <NO-CARRIER,BROADCAST,MULTICAST,SLAVE,UP> mtu 1500 qdisc mq master bond0 state DOWN qlen 1000
link/ether 88:94:71:xx:xx:xx brd ff:ff:ff:ff:ff:ff
RX: bytes packets errors dropped overrun mcast
0 0 0 0 0 0
TX: bytes packets errors dropped carrier collsns
41746 653 0 0 0 0
/sbin/ip -s addr:
: eth0: <NO-CARRIER,BROADCAST,MULTICAST,SLAVE,UP> mtu 1500 qdisc mq master bond0 state DOWN qlen 1000
link/ether 88:94:71:xx:xx:xx brd ff:ff:ff:ff:ff:ff
/sbin/ethtool eth0:
Settings for eth0:
Supported ports: [ MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: MII
PHYAD: 1
Transceiver: external
Auto-negotiation: on
Current message level: 0xffffffff (-1)
drv probe link timer ifdown ifup rx_err tx_err tx_queued intr tx_done rx_status pktdata hw wol 0xffff8000
Link detected: no