Skip to main content
NetApp Knowledge Base

BES-53248 both PSUs Warning LED ON and cannot be booted

  1. Last updated
  2. Save as PDF
Views:
769
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
hw
Last Updated:

Applies to

Broadcom BES-53248 switch

Issue

  • BES-53248 unresponsive and unable to boot
  • Both power supply units (PSU) direct current (DC) light emitting diodes (LED) are OFF and warning (!) LEDs are ON
  • Both PSU status LEDs are red on the front of the switch
  • All port LEDs are OFF on the front of the switch
  • No serial console output
  • Does not respond to ping
  • Faults persists after power cycle
  • Faults persists after replacing the PSU and power cord from a working switch

Front panel.jpg

Rear panel-PSU1.jpg

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.