Skip to main content
NetApp Knowledge Base

How to setup the BMC and change the IP address on SolidFire Nodes

  1. Last updated
    Aug 1, 2025
  2. Save as PDF
Views:
4,081
Visibility:
Public
Votes:
3
Category:
netapp-hci
Specialty:
hci
Last Updated:
8/1/2025, 1:10:08 PM

​

​

Applies to

  • NetApp SolidFire 
  • NetApp H-series 
  • baseboard management controller (BMC)
  • Intelligent Platform Management Interface (IPMI)

Description

This article describes the procedure to access BMC on the SolidFire/HCI node platforms and configure the settings.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.