Skip to main content
NetApp Knowledge Base

NetApp SolidFire nodes with "The system board PS(X) PG Fail voltage is outside of range" alert

  1. Last updated
  2. Save as PDF
Views:
250
Visibility:
Public
Votes:
0
Category:
sf-series
Specialty:
solidfire
Last Updated:

Applies to

  • SF38410 Nodes
  • SF19210 Nodes
  • SF9605 Nodes
  • SF4805 Nodes

Issue

At the Event Logs at the BMC/iDRAC of the node, there are repetitive alerts being generated. These alerts are cosmetic and can be ignored.

Example screenshots of the output can be seen in the Additional Information section of this article.

For further investigation, please contact NetApp Technical Support and refer to this article.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.