Skip to main content
NetApp Knowledge Base

Brocade G610 or Brocade 300 switch does not power on due to Faulty PSU

  1. Last updated
  2. Save as PDF
Views:
1,255
Visibility:
Public
Votes:
2
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade
Last Updated:

Applies to

  • Brocade G610 Switch
  • Brocade 300 Switch

Issue

  • Brocade switch suddenly turned off and does not power on.
  • Below steps need to be tried to isolate the issue further-
    • Check if power cords are tightly plugged in, on switch end and on power source.
    • Try connecting the power cord to a different power source.
    • Try powercycling the switch.
  • If issue persists, contact NetApp Technical Support and proceed to the solution.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.