Skip to main content
NetApp Knowledge Base

Reset occured on FCVI port xx - AutoSupport message

  1. Last updated
  2. Save as PDF
Views:
810
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • ONTAP 9
  • MetroCluster FC
  • Fiber Channel Virtual Interface (FC-VI)

Issue Summary

  • Reset occured on FCVI port xx messages occur when the replication to the Disaster Recovery (DR) site is briefly interrupted.
  • There is no immediate impact as a result of this issue but can be a general indication of FC Fabric instability.
  • Frequent resets can cause issues during a switchover/switchback operation.

 

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.