Skip to main content
NetApp Knowledge Base

splogd is running in degraded mode and having difficulty getting splogs from the SP FW

  1. Last updated
  2. Save as PDF
Views:
363
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • AFF systems
  • FAS systems
  • Service Processor (SP)
  • Bbaseboard management controller (BMC)

Issue

  • The following messages are logged by the controller
Sun May 30 19:17:11 +0200 [node-01: cf_worker: spmgmt.driver.timeout:error]: The software driver for the Service Processor (SP) detected a problem: Cannot send takeover configuration..
Sun May 30 19:17:11 +0200 [node-01: cf_worker: cf.hwassist.notifyCfgFailed:alert]: Failed to update the hardware-assist configuration with hardware component (SP): SP communication error(7).
Mon May 31 05:30:00 +0200 [node-01: splog_main: splog.warnings:error]: splogd is running in degraded mode and having difficulty getting splogs from the SP FW.
 
  • ::> node run -node node-01 sysconfig -a shows partial information for the SP
Service Processor Status: Online
Firmware Version: 5.7
Mgmt MAC Address: 00:A0:98:F5:3F:0C
Ethernet Link: down, full duplex, auto-neg complete
Using DHCP: no
IPv4 configuration:
IP Address: unknown
Netmask: unknown
Gateway: unknown
IPv6 configuration: Disabled

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.