Skip to main content
NetApp Knowledge Base

The SFP+ module installed is not supported with this network interface

  1. Last updated
  2. Save as PDF
Views:
585
Visibility:
Public
Votes:
1
Category:
data-ontap-8
Specialty:
hw
Last Updated:

Applies to

  • FAS2554
  • SFP(X6568-R6)
  • Converged Network Adapter (CNA) ports

Issue

During the SFP module (X6568-R6) is inserted, gets the following error in the console log:
 
The SFP+ module(unknown) installed in e0c is not supported with this network interface.
 
>sysconfig -a:
slot 0: 1G/10G Ethernet Controller CNA EP 8324
        (Dual-port, QLogic CNA 8324(8362) rev. 2)
        e0c MAC Address:    00:a0:98:7c:28:48 (auto-unknown-down)
        e0d MAC Address:    00:a0:98:7c:28:49 (auto-unknown-down)
        e0e MAC Address:    00:a0:98:7c:28:4e (auto-unknown-down)
        e0f MAC Address:    00:a0:98:7c:28:4f (auto-unknown-down)
 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.