Skip to main content
NetApp Knowledge Base

SP in rebooting status after ONTAP upgrade or maintenance activity

  1. Last updated
    Dec 27, 2023
  2. Save as PDF
Views:
1,300
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:
12/27/2023, 5:56:19 AM

Applies to

  • ONTAP 9
  • Service processor (SP)
  • Baseboard Management Controller (BMC)

Issue

  • The status of SP/BMC shows as rebooting after a maintenance activity:

Cluster::> system service-processor show

Node              Type   Status          IP Configured      FirmwareVersion          IP Address
----------------  ------ ---------------- ----------------- -----------------------  -------------------------
FAS8200-01        BMC    rebooting        true                     13.4P2            1.2.3.4
FAS8200-02        BMC    online           true                     13.4P2            1.2.3.5
2 entries were displayed.

  • The same status is observed from sysconfig -a output as well:

::> system node run -node <node> -command sysconfig -a

Service Processor           Status: Rebooting

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.