Skip to main content
NetApp Knowledge Base

Incorrect speed on management interfaces

  1. Last updated
    Apr 28, 2022
  2. Save as PDF
Views:
190
Visibility:
Public
Votes:
0
Category:
element-software
Specialty:
solidfire
Last Updated:
4/28/2022, 2:40:13 PM

Applies to

  • NetApp Element software
  • NetApp SF-series
  • NetApp H-series
  • Management interfaces (eth2 or eth3)

Issue

  • Switch reporting incorrect speed setting (lower than 1Gbs)
    %EC-5-CANNOT_BUNDLE2: Gi3/0/8 is not compatible with Gi3/0/9 and will be suspended (speed of Gi3/0/8 is 100M, Gi3/0/9 is 1000M)
    %EC-5-CANNOT_BUNDLE2: Gi3/0/11 is not compatible with Gi3/0/12 and will be suspended (speed of Gi3/0/11 is 10M, Gi3/0/12 is 1000M)
     
  • From storage node:
    # ethtool eth2
    Settings for eth2:
    <omitted>
            Speed: Unknown   (expected: 1000Mb/s)
            Duplex: Unknown  (expected: Full) 
    <omitted>

     
  • No alerts in NetApp SolidFire Active IQ (limited fault detection on management interfaces)

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.