Skip to main content
NetApp Knowledge Base

SolidFire block drive being ejected from the cluster repetitively (including replacement drives)

  1. Last updated
  2. Save as PDF
Views:
494
Visibility:
Public
Votes:
0
Category:
element-software
Specialty:
solidfire
Last Updated:

Applies to

All Element Software storage nodes

Issue

  • A drive is failed and replacement drive keeps being ejected after adding it back to the cluster and becomes available again.
  • Cluster shows an extended time (100s of hours or more) for block sync but it ends in a reasonable time. (Example screenshot can be seen in Additional Information)
  • blockServiceUnhealthy alert is being generated at Alerts section.
  • Unhealthy block service added event shown in the Events section as soon when the drive is being added to the cluster.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.