Skip to main content
NetApp Knowledge Base

SolidFire Bond10G goes down when flapping an interface during troubleshooting

  1. Last updated
  2. Save as PDF
Views:
565
Visibility:
Public
Votes:
1
Category:
sf-series
Specialty:
solidfire
Last Updated:

Applies to

  • NetApp SolidFire
  • Mellanox switches
  • Cisco switches
  • VMware vSphere

Issue

  • A storage node goes down when flapping eth0 or eth1 link manually during troubleshooting or when a switch is rebooted during maintenance or power outage
  • This results in partial to full loss of access to volumes hosted on the node
  • On occasions, this can also trigger mtuCheckFailure errors in NetApp SolidFire Active IQ

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.