Skip to main content
NetApp Knowledge Base

How to collect a Perfstat from ONTAP 9 using the CLI in Linux

  1. Last updated
    Jan 24, 2023
  2. Save as PDF
Views:
2,840
Visibility:
Public
Votes:
3
Category:
clustered-data-ontap-8
Specialty:
perf
Last Updated:
1/24/2023, 9:48:26 PM

​

​

Applies to

  • Perfstat 8.4 for Linux
  • ONTAP 9

Description

  • This article describes the procedure that should be followed to set up and collect a Perfstat from ONTAP 9 using the command line in Linux.
  • Perfstat 8.4 is currently supported in the following versions of Linux:
  • Note: Perfstat may run in other versions of Linux as long as the libraries required by perfstat are installed on the host.
    • RedHat 6.7
    • RedHat 7.2
    • Redhat 6.4
    • CentOS 6.6
    • CentOS 7

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.