Skip to main content
NetApp Knowledge Base

Disk assign failure due to single-path or path in same fault domain

  1. Last updated
  2. Save as PDF
Views:
1,080
Visibility:
Public
Votes:
0
Category:
disk-drives
Specialty:
hw
Last Updated:

Applies to

  • FAS / AFF models
  • ONTAP 9

Issue

  • Manual assignment of unassigned disk fails with the below message
 
NetApp-Cluster::*> storage disk assign -disk 1.1.2 -owner NetApp-01
 
Error: command failed: Failed to assign disks. Reason: Disk 1.1.2 is not assigned because it either has less than two paths or all its paths are connected to the same fault domain. Correct the configuration error or specify the -force option. For more details, use the "storage errors show" command.
 

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.