Skip to main content
NetApp Knowledge Base

snap reserve snapshots not autodeleted when over 100 percent

  1. Last updated
  2. Save as PDF
Views:
729
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
CORE
Last Updated:

Applies to

  • ONTAP 9.6P3

Issue

  • The snapshot autodelete is set on snap_reserve
  • The snap_reserve snapshots are not being autodeleted
  • The snap_reserve is bigger than 100% utilization:

::> df -h vol_name
Filesystem                 total      used   avail  capacity  Mounted on            Vserver
/vol/vol_name/             3170GB     2846GB 323GB  89%       /vol_name             svm_name
/vol/vol_name/.snapshot    792GB      1316GB 0B     166%      /vol_name/.snapshot   svm_name
2 entries were displayed.

  • The autodeletes were running fine when the snap_reserve was below 100%

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.