Skip to main content
NetApp Knowledge Base

SPARES_LOW ERROR messages when using ADP

  1. Last updated
    Dec 12, 2024
  2. Save as PDF
Views:
5,586
Visibility:
Public
Votes:
1
Category:
disk-drives
Specialty:
hw
Last Updated:
12/12/2024, 1:54:39 PM

Applies to

Issue

  • Spares are not available for root and/or data aggregates on each node.
  • Wellness NetApp Active IQ message example:

There are not enough XNNN_A12345B6CDE drives available in this storage appliance.

  • EMS message in one or more RAID groups and/or nodes. Example:

[node_name-01: config_thread: callhome.spares.low:error]: Call home for SPARES_LOW: /aggr1_data/plex0/rg1
[node_name-02: config_thread: callhome.spares.low:error]: Call home for SPARES_LOW: /aggr2_data/plex0/rg1

[node_name-01: config_thread: callhome.spares.low:debug]: Call home for SPARES_LOW: /aggr1_data/plex0/rg1
[node_name-02: config_thread: callhome.spares.low:debug]: Call home for SPARES_LOW: /aggr2_data/plex0/rg1

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.