Skip to main content
NetApp Knowledge Base

Missing onboard ports in sysconfig -a and network port show output

  1. Last updated
  2. Save as PDF
Views:
292
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • ONTAP 9
  • FAS
  • AFF

Issue

  • Onboard ports not listed under the output of following commands:

cluster1::> network port show
cluster1::> node run -node node1 -command sysconfig -a 

  • The ifgrp and vlans using those ports go down.
  • The issue persists despite power cycling the node.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.