Skip to main content
NetApp Knowledge Base

How to determine the firmware on a X91440A card post ONTAP 9.13.1 and later upgrade

  1. Last updated
  2. Save as PDF
Views:
257
Visibility:
Public
Votes:
0
Category:
not set
Specialty:
not set
Last Updated:

Applies to

  • ONTAP 9.13.1 and later
  • AFF A700, ASA AFF A700, FAS9000
  • AFF A900, ASA A900, FAS9500
  • X91440A 2-port 40GB network interface card

Description

  • SU553 describes a scenario where the firmware might not correctly update on a X91440A adapter after an upgrade to ONTAP 9.13.1 or later
  • This article describes methods to verify if the updated firmware has successfuly been applied after the upgrade is complete

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.