Skip to main content
NetApp Knowledge Base

After disabling automatic SP or BMC update, SPNotConfigured alerts occur periodically

  1. Last updated
  2. Save as PDF
Views:
305
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • FAS/AFF
  • Service Processor (SP)
  • Baseboard Management Console (BMC)

Issue

  • system controller show reports controller status is degraded.
  • The health monitor triggers the following alert frequently and clears it:
[nphmd: hm.alert.raised:alert]: Alert Id = SPNotConfiguredAlert , Alerting Resource = SP Config raised by monitor controller
[nphmd: hm.alert.cleared:notice]: Alert Id = SPNotConfiguredAlert , Alerting Resource = SP Config cleared by monitor controller
 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.