Skip to main content
NetApp Knowledge Base

Errors applying RCF file to Cisco Nexus 3132Q-V Cluster Switch

Views:
538
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
hw
Last Updated:
7/18/2025, 7:11:14 PM

Applies to

Issue

Errors seen  when applying RCF to the switch
 
switch(config)# interface port-channel1
switch(config-if)# switchport mode trunk
switch(config-if)# spanning-tree port type network
Warning: Bridge Assurance MUST be enabled at the remotely connected interface
switch(config-if)# mtu 9216
switch(config-if)# no shutdown
switch(config-if)# class-map type qos match-all HA
switch(config-cmap-qos)# match cos 5 
switch(config-cmap-qos)# policy-map type qos HA 
switch(config-pmap-qos)# class HA
switch(config-pmap-c-qos)# set qos-group 5
switch(config-pmap-c-qos)# class class-default
switch(config-pmap-c-qos)# set qos-group 0
switch(config-pmap-c-qos)# policy-map type queuing HA_EGRESS
Invalid class referenced
% Invalid command at '^' marker.
switch(config)# class type queuing c-out-8q-q6
ERROR: Cannot modify system defined queuing class-maps

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.