Skip to main content
NetApp Knowledge Base

Disk auto-assign not working after disk replacement

  1. Last updated
  2. Save as PDF
Views:
34
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • FAS8200
  • ONTAP 9
  • SAS(HDD)
  • X343_SSKBE1T8A10

Issue

  • After replacing a failed disk, the new disk was not automatically assigned to any node, even though disk auto-assign was set to ON
  • The disk appeared as unassigned and had to be manually assigned

Example:

CLUSTER::> disk option show

Node        Bkg. FW. Upd.   Auto Copy   Auto Assign   Auto Assign Policy
----------- --------------- ----------- ------------- ------------------
CLUSTER-01  on               on          on            default
CLUSTER-02  on               on          on            default
2 entries were displayed.

CLUSTER::> node run -node CLUSTER-01 -command disk show -n

DISK        OWNER        POOL   SERIAL NUMBER   HOME
----------- ------------ ------ --------------- --------
1c.21.16    Not Owned    NONE   xxxxxxxx

SYSCONFIG -A
21.16: NETAPP   X343_SSKBE1T8A10 NA05 1713.5GB 520B/sect (xxxxxxx)

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.