Skip to main content
NetApp Knowledge Base

Command fails when attempting to manually set port speed

Views:
194
Visibility:
Public
Votes:
0
Category:
aff-series
Specialty:
hw
Last Updated:
2/7/2025, 2:25:59 AM

Applies to

  • ONTAP 9
  • AFF-A220

Issue

  • Command fails when attempting to manually configure port speed.
  • Port is capable of desired speed
  • Command fails with output similar to the following:

::> network port modify -node Node-01 -port e0c -mtu 1500 -autonegotiate-admin false -duplex-admin full -speed-admin 1000 -flowcontrol-admin full

Warning: This command will cause a several second interruption of service on this network port.

Do you want to continue? {y|n}: y

Error: command failed: Port speed settings greater than 100Mb are not supported.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.