Skip to main content
NetApp Knowledge Base

Amber fault LED is on without hardware failure

  1. Last updated
  2. Save as PDF
Views:
2,736
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

​ ​

Applies to

  • ONTAP 9
  • FAS/AFF Systems
  • Internal disk shelves

Issue

  • The fault LED is lit on a disk but there are no issues reported about the disk.
  • There is no error in system controller service-event show output:

cluster1::> system controller service-event show
This table is currently empty.

  • The amber LED persists even after turning it off manually as mentioned in Disk has amber light without error.
  • Reseating the affected drive does not change the LED state.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.