Skip to main content
NetApp Knowledge Base

AFF-A250 amber LED on while no fault is present on the system

  1. Last updated
  2. Save as PDF
Views:
1,327
Visibility:
Public
Votes:
2
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • AFF A250
  • ONTAP 9
  • BMC 15.3 and earlier

Issue

  • Amber LED persistently set to ON for both of the nodes.
  • No faults are listed in ONTAP
cluster::> system health alert show
This table is currently empty.

cluster::> system health subsystem show
Subsystem         Health
----------------- ------------------
SAS-connect       ok
Environment       ok
Memory            ok
Service-Processor ok
Switch-Health     ok
CIFS-NDO          ok
Motherboard       ok
IO                ok
MetroCluster      ok
MetroCluster_Node ok
FHM-Switch        ok
FHM-Bridge        ok
SAS-connect_Cluster
                  ok
13 entries were displayed.
  • The LED is shown to be lit by the BMC:
::> system controller service-event show
  • No faults can be seen in the output of the 'bmc log debug' command from the BMC.
  • The issue persists through a full powercycle of the chassis.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.