Skip to main content
NetApp Knowledge Base

CONTAP-250835: X91440A NIC fails after a firmware update in ONTAP 9.13.1

  1. Last updated
  2. Save as PDF
Views:
113
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
hw
Last Updated:

Issue

  • On AFF A700, AFF A900, ASA A900, FAS9500 or FAS9000 systems, if you use an
    X91440A NIC port in 4x10G breakout configuration and you upgrade ONTAP to 9.13.1 or later, the port or card might fail to initialize with a FW checksum failure.
  • This issue does not pertain to X91440A ports in 40G configurations.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.