Skip to main content
NetApp Knowledge Base

CFSHELF-5432: During the DCM new firmware reload the soft reset is shown as watchdog reset

  1. Last updated
  2. Save as PDF
Views:
4
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
hw
Last Updated:

Issue

  • IOM/DCM firmware upgrade from IOM version 0311, DCM version 02010649 to IOM version 0411, DCM version 02200651
  • In DCM logs, during reboot to activate new DCM firmware

FLASH Programming complete - rebooting
 
Boot Cause:  Watchdog Reset
BS: I2C READY
BS: GPIO READY
BS: GPIO READY
I2C: i2cInitMAX7310 4/4 devices initialized (failed bus mask 0x00)
NOTE: DCM was reset by: Soft Reset

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.