Skip to main content
NetApp Knowledge Base

How to non-disruptively change between Active-Passive and ALUA failover modes on NetApp E-Series arrays connected to clustered Data ONTAP systems

  1. Last updated
  2. Save as PDF
Views:
1,618
Visibility:
Public
Votes:
1
Category:
e-series-systems
Specialty:
esg
Last Updated:

 

Applies to

  • Clustered Data ONTAP 8
  • SAN
  • FlexPod
  • E-Series Controller Firmware 8.xx
  • V-Series

Description

Starting with clustered Data ONTAP 8.2.3, 'Data ONTAP (ALUA)' Host type (Host Operating System) is supported and is recommended for use with NetApp E-Series storage arrays.
Note: In E-Series controller firmware 8.25 and later the Data ONTAP (RDAC) host type has been deprecated. The following procedure for changing the E-Series host type from RDAC to ALUA must be completed prior to upgrading to 8.25 and later.

The objective of this document is to provide a non-disruptive procedure to convert the host type on the NetApp E-Series array connected to clustered Data ONTAP systems. Changing the host type without following the recommended procedure might cause disruption to clustered Data ONTAP systems that are serving data.
You can utilize this non-disruptive procedure to perform the following for the E-Series arrays connected to the Data ONTAP system:

  • Switch existing configurations with DATA ONTAP (RDAC) host type to DATA ONTAP (ALUA) host type
  • Switch existing configurations with DATA ONTAP (ALUA) host type to DATA ONTAP (RDAC) host type

Note: The term ‘Data ONTAP system’ in this article refers to V-Series systems and FAS systems with the capability of attaching to storage arrays
On NetApp E-Series arrays, ALUA host type is supported from firmware version '08.10.15.00' onwards.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.