Skip to main content

This Site will be down for up to 3 hours on December 2, 2023 from 8 PM - 11 PM PST, to deploy an infrastructure update.

NetApp Knowledge Base

Unable to change IP with Mellanox on MLAG

  1. Last updated
  2. Save as PDF
Views:
371
Visibility:
Public
Votes:
0
Category:
netapp-hci
Specialty:
nas
Last Updated:

Applies to

  • Mellanox SN2010
  • ONYX 3.8.1174.and lower
  • MLAG enabled

Issue

  • When changing IP addresses, the new address becomes intermittently unavailable
  • When this occurs, there may be associated errors in the switch logs (as generated by sysdump) along these lines:

HCI-MLX2 mlagd[4799]: TID 140503404242688: [mlagd.NOTICE]: [MLAG_MAC_SYNC_PEER_MANAGER.NOTICE] Need to mark the MACs as DENY, cnt:0 < record_num:67

HCI-MLX2 mlagd[4799]: TID 140503404242688: [mlagd.NOTICE]: [MLAG_MAC_SYNC_PEER_MANAGER.NOTICE] Failed to grow the pool size, err -12

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device