Skip to main content
NetApp Knowledge Base

"system service-processor network modify" command is not accepted normally

  1. Last updated
  2. Save as PDF
Views:
208
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • ONTAP 9
  • Baseboard Management Controller(BMC)
  • Service Processor (SP)

Issue

The SP/BMC IP address does not change after running the system service-processor network modify command:

::> system service-processor network modify -node localhost -address-type IPv4 -enable true -ip-address 17.85.162.XX
-netmask 255.XXX.XXX.XXX -gateway 17.85.162.XX

::> system service-processor network show
                                                                        
                             Address
Node          Status         Family    Link State  IP Address
------------- -------------- --------- ----------- ------------------------
localhost     online         IPv4      down        17.80.160.XXX

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.