Skip to main content
NetApp Knowledge Base

System Manager reports "The partner node details were not found for the node..." during Initialize Storage System process

Views:
1,035
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
om
Last Updated:

Applies to

ONTAP 9

ONTAP System Manager (OSM) new cluster WIZARD

Issue

  • After entering initial information for a new ONTAP cluster setup and browsing to System Manager via the node management IP address, only one node is seen
  • the HA partner is not seen, and the following error is presented in the Initialize Storage System section:

The partner node details were not found for the node with the following serial number: . If all the nodes were not found, then check the node connections, reload the cluster setup wizard, and then try to set up the cluster again.

System Manager Error.JPG

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

Scan to view the article on your device