Skip to main content
NetApp Knowledge Base

AutoSupport Message: Power supply PSx input missing or out of range

  1. Last updated
  2. Save as PDF
Views:
2,688
Visibility:
Public
Votes:
1
Category:
solidfire-chassis
Specialty:
solidfire
Last Updated:

​ ​

Applies to

  • NetApp Element software
  • NetApp SolidFire
  • NetApp HCI

Issue

  • Error message in NetApp SolidFire Active IQ:

Power supply PS<x> input missing or out of range. -OR-  
powerSupplyError Power supply PS<x> is failed

(where PS<x> = PS1 or PS2)

  • The node can continue to function normally with a single failed power supply, however additional power supply faults could cause the node to fail so the alert should be addressed with priority

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device