Skip to main content
NetApp Knowledge Base

OPS panel/display panel fails on DS2246 and FAS2240

  1. Last updated
  2. Save as PDF
Views:
815
Visibility:
Public
Votes:
0
Category:
disk-shelves
Specialty:
hw
Last Updated:

Applies to

  • DS2246
  • FAS2240-2
  • FAS2552

Issue

  • Amber light on controller is observed along with corresponding EMS message
    • DS2246 (S/N xxxxxxxxxx) shelf 0 on channel 0a display warning for Display 1: not installed or failed; display panel failed. This module is on the front side of the shelf, at the left. Fault reported on disk storage shelf attached to channel 0a. Please check fans, power supplies, disks, and temperature sensors.

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.