Skip to main content
NetApp Knowledge Base

Node shuts down and fails to boot due to 'SP IPMI failure'

Views:
3,256
Visibility:
Public
Votes:
2
Category:
aff-series
Specialty:
HW
Last Updated:

Applies to

  • AFF A700 / FAS9000
  • Service Processor firmware version below 4.9

Issue

  • Both nodes shut down and fail to boot
  • Motherboards re-seated but nodes are held at LOADER prompt
  • The node shuts down with the following message:

sp.ipmi.lost.shutdown:EMERGENCY]: SP heartbeat stopped and cannot be recovered. To prevent hardware damage and data loss, the system will shut down in 2 minutes.

  • An Autosupport maybe seen with

HA Group Notification (SP HBT STOPPED) ALERT

  • Upon attempt to boot:

Initializing System Memory ...
Loading Device Drivers ...
Waiting for SP ...
IPMI:Enable PCI slots:timeout
SP failure. Resetting SP from primary FW. This can take a few minutes
Waiting for SP ...
SP recovered successfully after a reset from primary FW image
Waiting for SP ...

IPMI:Enable PCI slots:timeout
SP failure. Resetting SP from backup FW. This can take a few minutes
Waiting for SP ...
SP recovered successfully after a reset from backup FW image
Waiting for SP ...

IPMI:Enable PCI slots:timeout
Failed to recover SP
IPMI PCI Slot Control failed.

IPMI PCI Slot Configuration failed.

Configuring Devices ...
IPMI:Get controller FRU inventory:failed
IPMI:Get midplane FRU 0 inventory:failed
IPMI:Get NVRAM FRU inventory:failed

CPU = 2 Processor(s) Detected.
  Intel(R) Xeon(R) CPU E5-2697 v4 @ 2.30GHz (CPU 0)
  CPUID: 0x000406F1. Cores per Processor = 18
  Intel(R) Xeon(R) CPU E5-2697 v4 @ 2.30GHz (CPU 1)
  CPUID: 0x000406F1. Cores per Processor = 18
524288 MB System RAM Installed.
SATA (AHCI) Device: SV9MST6D120GLM41NP

Boot Loader version 6.0.12
Copyright (C) 2000-2003 Broadcom Corporation.
Portions Copyright (C) 2002-2021 NetApp, Inc. All Rights Reserved.

BIOS POST Failure(s) detected: SP IPMI failure. Abort AUTOBOOT

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.