Skip to main content
NetApp Knowledge Base

Network port down after ONTAP upgrade with switch running CISCO NXOS 9.3(8)

Views:
1,391
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • ONTAP 9
  • ONTAP upgrade
  • Switchless configuration
  • CISCO NXOS  9.3(8)

Issue

  • After ONTAP upgrade data port e0e is down. Port e0e is connected to CISCO switch
sysconfig -a
slot 0: 1G/10G Ethernet Controller CNA EP 8324
(Multiple Dual-port, QLogic CNA 8324(8362) rev. 2)
e0e MAC Address: 00:a0:98:xx:xx:xx (auto-unknown-fd-down)
e0f MAC Address: 02:a0:98:xx:xx:xx (auto-10g_twinax-fd-up)
e0c MAC Address: 00:a0:98:xx:xx:xx (auto-unknown-fd-down)
e0d MAC Address: 00:a0:98:xx:xx:xx (auto-unknown-fd-down)
Device Type: EP8324N
Firmware Version: 5.4.66.0
  • Port remains down after cable/SFP reseat on both ends

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.