Skip to main content
NetApp Knowledge Base

Fan module latches but does not engage on FAS8300/FAS8700/A400 platforms

Views:
115
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • FAS8300
  • FAS8700
  • AFF A400
  • Fan Module

Issue

The fan module on a FAS8300, FAS8700, or AFF A400 might latch, but not fully engage in the chassis to receive power and provide air flow

 

clipboard_e8936ff28baa4869698369ef21c0393de.png

 

 

  • Fan on the left (highlighted green) is appropriately seated with the black handle and silver housing flush with the chassis
  • Fan on the right (highlighted red) is not properly seated as seen with the black handle and silver housing protruding outside the chassis

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
  • Was this article helpful?