Skip to main content
NetApp Knowledge Base

Cluster Join fails due to down cluster ports

  1. Last updated
  2. Save as PDF
Views:
75
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
hw
Last Updated:

Applies to

  • FAS AFF
  • Ontap 9

Issue

  • Cluster ports were not properly cabled before attempting the cluster join
  • After the ports a correctly cabled and brought online the cluster join still fails with below error
    Error: Unused cluster ports exist in the cluster. One or more ports may not be in the "healthy" state, or may be incorrectly assigned to the "Cluster" Ipspace. Run "network port show -ipspace Cluster" to view the cluster ports.Correct any issues, and then try the command again.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.