Skip to main content
NetApp Knowledge Base

Aggregate reconstruction gets continuously suspended

Views:
443
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
hw
Last Updated:

Applies to

  • AFF8080
  • ONTAP 9.5P4

Issue

Aggregate reconstruction is suspended and resumed every few minutes without any progress
 
Thu Jun 11 12:29:34 +0200 [DK01NETAPP01-02: config_thread: raid.rg.recons.start:notice]: /aggr02/plex0/rg2: starting reconstruction, using disk 4a.00.6P2, disk block 5248
Thu Jun 11 12:31:35 +0200 [DK01NETAPP01-02: config_thread: raid.rg.recons.start:notice]: /aggr02/plex0/rg2: starting reconstruction, using disk 4a.00.6P2, disk block 5248
Thu Jun 11 12:33:36 +0200 [DK01NETAPP01-02: config_thread: raid.rg.recons.start:notice]: /aggr02/plex0/rg2: starting reconstruction, using disk 4a.00.6P2, disk block 5248

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.