Skip to main content
NetApp Knowledge Base

Volume move fails after stopping volume clone split

Views:
464
Visibility:
Public
Votes:
1
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

  • ONTAP 9.6
  • ONTAP 9.7

Issue

  • After stopping a volume clone split operation, volume move start commands fail:
 
Cluster01::> volume move start -volume test_clone -destination-aggregate aggr1
 
Error: command failed: Cannot move volume "test_clone" in Vserver "svm1". Reason: The volume is undergoing a FlexClone split operation. Use the "volume clone split show" command to monitor the split operation for completion, or use the "volume clone split stop" command to stop the split operation.
 
  • The volume clone split status command shows all zeroes:
 
Cluster01::> volume clone split status
 
                              Blocks
                        -----------------
Vserver   FlexClone     Scanned  Updated  % Complete
--------- ------------- -------- -------- ----------
svm1      test_clone    0        0        0

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.