Skip to main content
NetApp Knowledge Base

E-Series controller may reboot due to interaction with Brocade FC switch

  1. Last updated
  2. Save as PDF
Views:
207
Visibility:
Public
Votes:
0
Category:
e-series-santricity-os-controller-software
Specialty:
esg
Last Updated:

Applies to

  • E-Series controllers using 16Gb or 32Gb fibre channel host interfaces
  • Controllers running firmware prior to 8.30.4X.XX, 11.30.4, 8.40.1X.XX, and 11.40.1
  • Brocade FC switch connected to controllers

Issue

In rare cases, a controller may reboot when connected to a Brocade switch and running a controller firmware version less than listed above.
Controller may report the following in the exception log:
Page Fault errCode: 0 pc: 0xffffffff83a2b87a
_ZN3fcd13HMtlInterface12sendElsReplyEP16BUILD_SEND_FRAME + 0x4a
or
SIGSEGV Received
(with the following contained in the backtrace)
fcd::HMtlInterface::sendElsReply(BUILD_SEND_FRAME*)

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.