Skip to main content
NetApp Knowledge Base

ONATP Select Node Failed to Takeover, Failover Disabled by System

  1. Last updated
  2. Save as PDF
Views:
14
Visibility:
Public
Votes:
0
Category:
virtual-storage-console-for-vmware-vsphere
Specialty:
VIRT
Last Updated:

Applies to

  • ONTAP SELECT
  • SW-SUBS-OTSCP-M300-PX

Issue

  • During a scheduled maintenance activity, the customer performed a VMotion migration of ONTAP Select cluster nodes ots001-01 and ots001-02 from an Intel-based ESXi host to an AMD-based ESXi host. 
  • After issuing a storage failover takeover command "storage failover-takeover -ofnode ots001-02 -halt true", node ots001-01 did not complete the takeover. Storage failover was disabled by system. The cluster was left in a state where takeover and giveback operations were not possible.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.