Skip to main content
NetApp Knowledge Base

Failed to add capacity for ONTAP Select with error NodeVMNotFound

  1. Last updated
  2. Save as PDF
Views:
328
Visibility:
Public
Votes:
0
Category:
ontap-select
Specialty:
ontapselect
Last Updated:

Applies to

ONTAP Select Deploy 9.4.29

Issue

  • Failed to add capacity for ONTAP Select with error as below:
StorageAddFailed
NodeVMNotFound: Node "ONTAPSelect-01" in cluster "ONTAPSelect" not found on any host. If the cluster has been reconfigured outside of ONTAP Select Deploy, run a refresh operation on the cluster, and then try the operation again.
  • The node is degraded.
  • Ran a cluster refresh, which failed with error unknown, issue persists that the node is degraded and failed to add capacity from the ONTAP Select cluster.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.