What issues are resolved in the ATTO FibreBridge Firmware?
- Views:
- 3,094
- Visibility:
- Public
- Votes:
- 1
- Category:
- metrocluster
- Specialty:
- metrocluster
- Last Updated:
- 7/7/2023, 2:11:47 PM
Applies to
- ATTO 7500N FibreBridge
- ATTO 7600N FibreBridge
Answer
7600N | 7500N | Issue | Description |
---|---|---|---|
4.40 | 3.40 | BUG 1283307 | Additional logging for L4 Watchdog resets |
BUG 1479134 | In band commands can not be run on a secured bridge | ||
4.35 | 3.35 | BUG 1193024 | Display SFP RX and TX power for FC |
BUG 1378960 | CRIT Data Abort Exception (007A) | ||
4.30 | 3.30 | BUG 1359513 | Critical Software Error Detected - duplicate IPv6 address on MP1 |
BUG 1382156 | Critical Software Error Detected - Duplicate IP during security scanner run | ||
BUG 1396995 | FibreBridge is not producing a coredump in rare situations | ||
BUG 1398026 | Disk reservation conflicts | ||
4.25 | 3.25 | BUG 1316751 | scsi.cmd.pastTimeToLive error on ATTO FibreBridge 7X00 |
BUG 1345574 | ATTO FibreBridge unexpected reboot, CRIT Data Abort Exception | ||
BUG 1353219 | Critical prefetch abort exception detected on ATTO 7500N | ||
BUG 1356900 | System reports "watchdog timer interrupt exception" message | ||
BUG 1342275 | ATTO FibreBridge 7500N performs an unexpected reboot when a CRIT parity error is detected | ||
BUG 1331834 | "CRIT Parity Error" occurs on FibreBridge 7500N bridge during I/O operations | ||
4.20 | 3.20 | BUG 1283307 | Reset. HW Code: L4 Watchdog 0 Warm |
BUG 1310201 | ATTO FibreBridge reboots unexpectedly | ||
BUG 1320900 | Improved error handling for In-Band upgrades | ||
4.17 | 3.17 | BUG 1317514 | ATTO Fibrebridge firmware 3.16 and 4.16 might cause disk drives to go into error recovery mode during a disk firmare update |
4.16 | 3.16 | BUG 1238281 | ATTO FibreBridge reboots unexpectedly |
BUG 1278364 | ATTO FibreBridge reboots unexpectedly | ||
BUG 1255763 | Long CP while updating FibreBridge via in-band upgrade | ||
BUG 1253119 | ATTO FibreBridge reboots unexpectedly | ||
BUG 1255967 | ATTO FibreBridge 7500N reporting "Enclosure services" errors | ||
4.10 | 3.10 | BUG 1221973 | ATTO 7500N FibreBridge might reboot if configuration is not saved |
RFE 1248368 | autosave configuration on sas port changes and fc port changes | ||
BUG 1222609 | |||
BUG 1224840 | ATTO FibreBridge might reboot unexpectedly | ||
BUG 1226819 | ATTO web interface displays misformatted output for the dumpconfiguration command not correctly displayed in the ATTO web interface | ||
BUG 1230248 | Port informations might be displayed incorrectly | ||
BUG 1231056 | |||
BUG 1232985 | |||
BUG 1241214 | Password changes for the ATTO FibreBridge might not work when using web GUI | ||
BUG 1222764 | ATTO FibreBridge reboots unexpectedly | ||
BUG 1239024 | ATTO FibreBridge reboots unexpectedly | ||
BUG 1233471 | ATTO FibreBridge reboots unexpectedly due to a incomplete log entry | ||
BUG 1240823 | ATTO FibreBridge reboots unexpectedly due to a incomplete log entry | ||
BUG 1249578 | ATTO FibreBridge reboots unexpectedly | ||
BUG 1236772 | ATTO FibreBridge reboots unexpectedly | ||
4.05 | 3.05 | BUG 1239717 | improvements in telnet response handling |
BUG 1229880 | Bridge might log in with wrong WWN | ||
BUG 1093714 | Firmware updated to resolve a negotiation issue when bridge was hard set for 8Gb or 4Gb | ||
BUG 1188132 | Improved error handling to properly account for the case of a Bridge LUN Reservation conflict when the original reservation owner has logged out | ||
N/A | 2.96 (012U) | BUG 1206283 | Possible reboot on duplicate IPv6 address |
BUG 1114537 | L4 Watchdog 0 Warm reboot | ||
BUG 1207603 | Denial of Service Vulnerability in ATTO FibreBridge 7500N | ||
2.95 (012N) | BUG 1142834 | Unable to log in to the web interface | |
BUG 1172486 | incorrect translation of Reservation Conflict status from BSAS drives | ||
BUG 1018732 | Ability to change the SNMP community string | ||
2.90 (002N) | BUG 1090526 | ATTO FibreBridge 7500N network port interface | |
BUG 1119516 | ATTO 7500N FibreBridge might reset and reboot due to false parity errors | ||
BUG 1103397 | |||
BUG 1107337 | Checksum errors after SAS IOP firmware fault on the FibreBridge | ||
2.85 (005Q) | BUG 1061776 | ATTO FibreBridge 7500N logging 'Command out of resources' messages | |
BUG 1074470 | ATTO FibreBridge 7500N logging 'Command out of resources' messages | ||
BUG 1017732 | ATTO 7500N FibreBridge can restart unexpectedly | ||
BUG 1094861 | Multi-stream writes to SSDs behind an ATTO 7500N FibreBridge can cause system latency issues | ||
BUG 1087100 | bridgename can not be set to include _ or - | ||
2.80 (003T) | BUG 1073564 | Watchdog Timer Interrupt Exception | |
BUG 1059004 | False Parity Errors Exception | ||
BUG 1061739 | Reboot with Reason: Watchdog Timer Interrupt Exception | ||
BUG 1049176 | Disk Level checksum verification failure on WRITE VERIFY | ||
BUG 1061776 | Command out of Resources | ||
BUG 1017732 | Data Abort Detected Exception | ||
2.77 | BUG 1033626 | ATTO 7500N FibreBridge LUN mapping inconsistency | |
BUG 1020732 | Incorrect dual-path configurations to the same ATTO 7500N FibreBridge might cause disk ownership issues | ||
BUG 1026798 | Hot adding or removing a shelf in quick succession to an ATTO 7500N FibreBridge might cause a misdirected I/O | ||
2.73 | BUG 1017018 | Retrieval of the ATTO 7500N FibreBridge logs might trigger a RAID block checksum error | |
BUG 1019611 | False "SAS event error (IOMB)" log file entries | ||
2.71 (011Z) | BUG 1011763 | ||
2.41 | none | Initial Release |
Additional Information